One IP for every branch

One static IP for every office and branch

Connect each office, shop or plant to the same TunnelYard gateway over IPsec. Every site's internet traffic leaves from one static IP, so your apps and partners allow-list one address instead of one per line.

HQFortiGateBranchMikroTikShopUbiquitiPlantOT · pfSenseInternet servicessee one IPYour gateway203.0.113.10static IPone IP for every siteIPsec tunnelinternet, from 203.0.113.10

Connects to standard IPsec firewalls and routers

Why multi-site teams use one gateway

One address for the whole company

Up to 4 sites on Business and unlimited sites on Enterprise, all leaving from the same static IPv4.

Rules for every site

Allow and deny rules by tunnel, subnet, protocol and port, up to 200 on Enterprise, with rule logging and hit counters.

Uptime you can show

Alerts by email, webhook, Slack or Teams, and a monthly per-tunnel uptime report as a PDF on Enterprise.

How it works

Up and running in four steps

  1. 1

    Launch the gateway

    Pick a location close to most of your sites. It's ready in 10–15 minutes with its own static public IPv4.

  2. 2

    Add a tunnel per site

    Each site gets its own tunnel, pre-shared key and LAN subnets, and a config for its own firewall.

  3. 3

    Allow-list one IP

    Give the gateway's IP to your apps and partners once, for every site.

  4. 4

    Watch every site

    See which tunnels are up, how much traffic each site sends, and get an alert when one has been down for 2 minutes.

Features you'll use

Built for this job

All features

Custom IPsec proposals

On Enterprise, set custom IKE and ESP proposals, lifetimes and dead-peer detection to match each site's firewall.

365 days of history

Traffic and uptime per tunnel, plus latency and packet loss when you set a ping target, kept for 365 days on Enterprise.

On-call support

Enterprise includes email and Slack support plus on-call support, with a 99.9% SLA.

FAQ

Questions about multiple sites

How many sites can share one IP?

Each site has its own tunnel to the gateway. Starter includes 1 tunnel, Business up to 4 and Enterprise unlimited, and every site's internet traffic leaves from the same static IP. See pricing.

Can our sites reach each other through the gateway?

No. TunnelYard carries each site's outbound internet traffic, so the sites share one IP but don't reach each other's networks through the gateway.

Can sites use different firewall brands?

Yes. Each tunnel has its own peer IP, LAN subnets, pre-shared key and crypto preset, and you export a config for the device at that site, whether it's a FortiGate at HQ or a MikroTik in a shop.

Can we control what OT and IoT sites can reach?

Yes. Firewall rules match on tunnel, source and destination subnet, protocol and ports, and the first match wins: up to 20 rules on Business and 200 on Enterprise, with rule logging and hit counters on Enterprise.

Which alerts and reports do we get?

When a tunnel has been down for 2 minutes, an alert goes out, followed by a recovery message when it is back: email on every plan, webhooks on Business, and Slack and Teams on Enterprise. Enterprise also gets a monthly per-tunnel uptime report as a PDF.

How much does it cost?

Business is $250 and Enterprise $400 per gateway per month, excluding VAT. See pricing for what each plan includes.

Get a static IP for your office

Launch a gateway, connect your firewall, and allow-list one IP today.